Blog · Reading the risk · · 5 min read
How Far Behind Is Satellite Seaweed Data, and What Does It Miss?
NOAA and the University of South Florida refresh their seaweed products daily but publish no processing delay. Seaweed Radar's own data runs one to two days behind. It also misses small patches and anything the sensors cannot see.
A "daily" label is a refresh schedule, not a promise about how old the picture is. The gap between the satellite pass and the number you read is real, and so are a few things the sensors cannot see at all.
What does "updated daily" actually mean?
It means the product is rebuilt each day, and neither agency says how old the underlying imagery is. NOAA's Sargassum Inundation Risk page says the map is "updated daily" and labels it experimental. The University of South Florida's Sargassum Watch System also describes daily updates. Neither page gives a processing time.
Seaweed Radar repeats NOAA's risk levels, and its own how it works page states that the data runs one to two days behind. So the level you see for a coast describes seaweed offshore a day or two ago. The lag is short next to a bloom season. Even so, a shift in wind or current can change a coast inside it. If you want the levels explained first, here is how to read NOAA's four risk levels.
How small a patch can a satellite see?
Not a small one, at least not with the sensors that cover the whole ocean every day. USF lists the satellites behind its bulletin, and the trade between detail and coverage is easy to see:
| Sensor | Pixel size | Revisit |
|---|---|---|
| MODIS (Terra and Aqua) | about 1,000 m | near-daily |
| VIIRS | 750 m | daily |
| Landsat 8 OLI | 30 m | every 16 days |
A raft narrower than a pixel can vanish into the pixel's average. USF notes that higher-resolution satellites typically cover smaller areas and do not provide daily coverage, so the sharp view arrives rarely. This is also why a map can look calm while a narrow line of seaweed sits just off a cove. The index these sensors use flags floating algae and other material on the ocean surface, so a bright pixel is a clue, not a species ID.
Why is the map not a beach report?
Because NOAA's method looks well away from the sand. For each coastal pixel, the SIR algorithm examines floating algae data in the surrounding 50 to 100 km and compares it with a multiday baseline. The difference sets the level. It's why a level covers a run of coast, not one beach.
Then the sea gets a say. NOAA's Climate.gov explains that weather, waves and eddies can pull large patches out of the main current and carry them to shore. USF goes further: its FAQ says predicting beaching at an individual beach is difficult or impossible, because winds, tides and circulation all affect it.
NOAA also states that the product is not a forecast. It estimates the potential for seaweed to wash ashore.
What do the black pixels mean?
Black means insufficient data, and that is all NOAA says about it. For a traveller, the practical meaning is simple: on that day, for that stretch, the map has nothing to add. The page does not explain the cause, and it does not describe how clouds are handled or how big a coastal pixel is. Treat a black patch as a gap in what anyone knows, not as a quiet stretch of water.
NOAA adds that its data are "at various levels of quality and maturity" and carry no warranty of fitness for outside use. That is a fair reason to read any level as one input among several. NOAA's own wording matters here: the product is experimental, and its credits list data from NOAA/NESDIS, NASA and the Copernicus Programme without saying which datasets feed which map. What you're looking at is a working tool, not a finished measurement.
What do satellites do well?
They are good at the big picture. Climate.gov notes that the spring 2023 bloom was the densest observed in March since scientists began tracking the phenomenon with satellite images about twenty years ago. No beach walker or boat crew could have measured that across an ocean. The same article says the seaweed belt moves north with the Intertropical Convergence Zone toward summer, and that density declines over fall and winter.
So the data is strong on where the belt is and which way it is heading, and weaker on the last kilometre before the shore. Both facts matter when you read a level for a trip.
How do you use a map that is late and incomplete?
Use it as context for your coast, and check it more than once, ideally in the days before you leave and again once you arrive. A few habits help:
- Look at several days in a row, not a single day. A level that holds for a week says more than one reading.
- Read the level as offshore seaweed that could arrive, not as the state of the sand.
- Treat black or missing data as unknown.
- Pair it with a recent photo or a hotel's own report for the specific beach. Ask for one from this morning, not last week.
- Remember that a level refreshed today still describes seaweed offshore a day or two earlier, so a change in wind or current since then is not in it.
The glossary defines the terms you will run into on the maps.
Bottom line
Satellite seaweed data is refreshed daily but arrives a day or two late on this site, and it sees offshore patches better than small ones near shore. Use it to judge the odds for a stretch of coast, then confirm the beach itself close to your trip. For more explainers like this one, see the blog.
Questions
- How old is the data on a satellite seaweed map?
- NOAA and the University of South Florida say their products are updated daily, but neither page states a processing delay. Seaweed Radar's own pages say the data it shows runs one to two days behind.
- Why is part of the NOAA map black?
- NOAA marks black pixels as insufficient data. The page does not say why, so read black as unknown, not as no seaweed.
- Can satellites see small patches of seaweed?
- Only partly. USF lists pixels of about 1,000 m for MODIS and 750 m for VIIRS. Landsat 8 sees 30 m, but it returns only every 16 days.
- Is the NOAA risk level a forecast?
- No. NOAA calls the product experimental and says it is not a forecast. It estimates the potential for seaweed to wash ashore.
Sources
- NOAA AOML: Sargassum Inundation Risk (SIR)
- USF Optical Oceanography Lab: Sargassum Watch System (SaWS)
- NOAA Climate.gov: Massive bloom of seaweed in tropical Atlantic raises risk for Caribbean, Gulf and Florida
Tags: satellite-data, noaa-sir, data-limits, black-pixels, usf-saws
See the newest risk level for 399 beaches, or read how the levels work.